Ä¢¹½tv

Final rule requires a 90% reduction in ethylene oxide emissions from commercial medical device sterilization facilities

On March 14, the Environmental Protection Agency announced to the Clean Air Act standards to reduce ethylene oxide (EtO) emissions from medical device sterilization facilities by 90%, one of the in U.S. history. This reduction is even more stringent than EPA's April 2023 proposal, which called for an 80% reduction of EtO emissions to outdoor air from commercial sterilizers. 

EtO is used to sterilize about  in the U.S.; however, EPA has concluded that EtO is a human carcinogen with a high estimated cancer potency based on data from a study of sterilization workers. That estimate has been challenged, as the Texas Commission on Environmental Quality (TCEQ) estimated a substantially lower cancer potency using the same data. The National Academies of Sciences, Engineering, and Medicine are establishing an ad hoc committee to review the TCEQ analysis.

While the debate over EtO's cancer potency continues, this announcement puts added pressure on sterilizing facilities and the medical device industry at large to develop viable alternative sterilization methods or to identify alternative materials for their products.

AdvaMed, the world's largest medical technology association, has that implementation of EPA's rule could cause up to a 50% reduction in EtO sterilization capacity for medical technologies and widespread delays in patient care. They also highlighted that medical device sterilization uses half of one percent of all commercially produced EtO.

New compliance timeline for EtO emissions standards

After the April 2023 proposed standards were issued indicating 18 months for compliance, some stakeholders expressed concerns that requiring EtO facilities already at capacity to find alternative ways of sterilizing medical devices might cause facility closures and create a shortage of sterile medical devices, leading to treatment delays for patients.

Under the new rule, a company's compliance time is based on how much EtO they use. According to the , the more EtO a facility uses, the shorter the deadline for compliance due to increased risk. The final rule will affect emissions at 88 commercial sterilization facilities operated by approximately 50 companies:

According to EPA, the compliance schedule is designed to provide sufficient time for sterilizing medical equipment while installing and testing new monitoring and emission control systems and equipment that will protect workers and communities.

Continuous air monitoring

The final rule requires facilities to continuously monitor EtO emissions, complete quarterly reports, and "install available and proven technologies, practices, and procedures which have been demonstrated to significantly reduce EtO emissions." 

EPA is in the process of finalizing the following amendments to the National Emission Standards for Hazardous Air Pollutants (NESHAP), which commercial sterilizers using EtO must follow under the final rule:

EPA developed the final rule after conducting national webinars, public hearings, and public meetings, as well as collecting more than 40,000 comments from the rulemaking docket.